DL320 Preform Injection Molder

Extended material heating chamber
Extended ejection stroke
Extended screw with special screw ratio
Fully computerized servo controls
Programmable computer screen interface (allowing operation of machine with a single press of a button)
Material flow controller:
If one cavity is blocked the material flow will be adjusted for 3 cavities instead of four also if the PET material should jam in the system the injection process is automatically deactivated, preventing mold damage and material over-flow (problems which occur in regular injection molding equipment)
The operating the system is easily programmable Settings can be programmed for various molds for different preform weights. Once the settings are made, all the operator has to do is recall the settings, and start the injection process. This ease of use also means that the operator can operate the machine with just a press of a button.
Our equipment body is rust free .We only use quality parts. The mother board and controller boards is from Fuji Electronics, Japan. Most of the switches and mechanical relays are from Telemecanique, France

A) DL320 sp-320 Ton injection machine for preforms of up to 750m grms, single cavity:
Included: Hopper-dryer with 200 kg resin storage.
Pet auto loader
Chiller
Cooling Tower
Pet Resin Dehumidifier

Single cavity mold
Resin grinder

Total ex works: $98,000

Installation @ $600 daily for 10 days

Production speeds 40/50 b/hr on a 24/7 basis; say 1000 bottles / 24hours

B) DL 320 sp- 320 Ton injection machine forpreforms of up to 400 grms, 3- cavity:
Included: Hopper-dryer with 400 kg resin storage.
Pet auto loader
Chiller
Cooling Tower
Pet Resin Dehumidifier
3-cavity mold
Resin grinder

Total ex works: $131,000

Installation @ $600 daily for 10 days

Production speeds 200 b/hr on a 24/7 basis; say 5000 b/24hours